Controller disconnects while playing

Message Topic Search Topic Options Post Reply Create New Topic Printable Version

   Problem solved.  I had the usb adapter connected to my monitors usb port.  I plugged it right into the pc and it works fine now.  Sorry!

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version
kennyz06 Members Profile Send Private Message Find Members Posts Visit Members Homepage Add to Buddy List Newbie Joined: 05 May 2008 Location: Texas Online Status: Offline Posts: 24	Quote Reply Topic: Controller disconnects while playing Posted: 07 Aug 2009 at 5:25pm
	Problem solved. I had the usb adapter connected to my monitors usb port. I plugged it right into the pc and it works fine now. Sorry!
	http://www.McKinneyChristmas.com

kennyz06 Members Profile Send Private Message Find Members Posts Visit Members Homepage Add to Buddy List Newbie Joined: 05 May 2008 Location: Texas Online Status: Offline Posts: 24	Quote Reply Posted: 07 Aug 2009 at 8:31am
	I'll test it this evening, but I know the cable is good. Also, it's only one controller I'm testing. The problem occurs in Aurora, I have not checked Borealis. I'll do that this evening
	http://www.McKinneyChristmas.com

LightsOnLogan Members Profile Send Private Message Find Members Posts Add to Buddy List Admin Group Joined: 11 Oct 2007 Online Status: Offline Posts: 3187	Quote Reply Posted: 07 Aug 2009 at 8:13am
	To answer the baud question: 56000 is the "official" spec, however both LOR and D-Light are designing their controllers to handle 115,200 these days. Now for the more difficult one, the controller that is losing heartbeat: 1) Is this happening with Aurora or Borealis? 2) Can you test by isolating to just one controller on a short Cat-5 cable just to make sure there isn't a cable issue?


kennyz06 Members Profile Send Private Message Find Members Posts Visit Members Homepage Add to Buddy List Newbie Joined: 05 May 2008 Location: Texas Online Status: Offline Posts: 24	Quote Reply Posted: 06 Aug 2009 at 9:51am
	I was testing out one of my LOR PC controllers last night and noticed that when I test my show, it will randomly disconnect the controller in the middle of the show. When I say it disconnects, I mean that the red led begins to flash durring the show. It will start off fine, and then start flashing. I havent tested it with other sequences yet, but I'd say its an issue if it even does it on one sequence. I'm running version 4.3 on the LOR board, and 1.69 of Aurora. Its an amd single core pc with 1gb of ram... running windows 7. Also, what baud rate should I be using for this? 56k? Thoughts?
	http://www.McKinneyChristmas.com