Aurora Homepage
Forum Home Forum Home > The Vault > I'm New From Spectrum And I Need Help!
  Active Topics Active Topics
  FAQ FAQ  Forum Search   Calendar   Register Register  Login Login

Forum LockedFades

 Post Reply Post Reply
Author
Message Reverse Sort Order
  Topic Search Topic Search  Topic Options Topic Options
LightsOnLogan View Drop Down
Admin Group
Admin Group


Joined: 11 Oct 2007
Online Status: Offline
Posts: 3187
  Quote LightsOnLogan Quote  Post ReplyReply Direct Link To This Post Topic: Fades
    Posted: 28 Nov 2008 at 10:49am
If they seem to hang at 15% and/or non-linear then this is probably a firmware issue.
 
Edit: Misunderstood the above but I get it now... I will look into this and involve the beta testers early next week, but as I mentioned earlier this might be a firmware issue and not Aurora itself.


Edited by LightsOnLogan - 28 Nov 2008 at 11:22am
Back to Top
beavis View Drop Down
Groupie
Groupie


Joined: 01 Sep 2008
Online Status: Offline
Posts: 15
  Quote beavis Quote  Post ReplyReply Direct Link To This Post Posted: 26 Nov 2008 at 10:56pm
Changed some of the fades to bottom out at 15%.  Seems like they race to 15%, and then stay at that same brightness for a noticable time before switching off at the end of the interval.
 
The fading definitely doesn't seem linear.
 
I also copied the same test sequence over to some channels on my 1.14 controller so I could watch them together, and it performs exactly the same as the 1.13 controller.
Back to Top
beavis View Drop Down
Groupie
Groupie


Joined: 01 Sep 2008
Online Status: Offline
Posts: 15
  Quote beavis Quote  Post ReplyReply Direct Link To This Post Posted: 26 Nov 2008 at 10:25pm

These circuits aren't LED's.  It's wierd because it looks good in the visualizer, but the ramps are definitely happening much faster than the interval.  I sequenced a short test sequence, and same thing.  Fades out are happening way faster in lights than they do in design (and as shown in the visualizer)

It's really bad in one sequence that's fade heavy.  I think I'll hold it out of the show on Friday until I figure out how to fix it.
Back to Top
LightsOnLogan View Drop Down
Admin Group
Admin Group


Joined: 11 Oct 2007
Online Status: Offline
Posts: 3187
  Quote LightsOnLogan Quote  Post ReplyReply Direct Link To This Post Posted: 26 Nov 2008 at 1:28pm
Jonathan is partially correct (LEDs behave differently and do so in fewer steps). 
 
The exact reason isn't the power requirements though.  In the most basic circuit design with a way oversimplified explaination, it has to do with the fact that the "perceived resistance" of the LED is not fixed as it is with an incandescent.  As the current changes, so does the resistance that must be used in ohms law calculations.  The controllers are designed to alter the overall power going into a fixed resistance, not a varying one.  The result is a non-linear gamma curve.  Add to that the fact that some LED vendors are now using voltage doubler circuits and other capacitive devices and the exact shape of the gamma curve becomes even more complex.
 
The only good way to get a linear fade out of an LED is through current regulation on a DC circuit.  Firefly is a good example of this.
 
Now back to the topic at hand... we don't even know if the OP has LEDs...
 
I do know D-Light has been working on numerous fixes to the ramp timings, so this might be a firmware thing.  The ramp calculations in Aurora are the correct ones.  I've noticed the same effect on Firefly though when helping in the Red to black through yellow thread.  It might be possible to add an option in playback preferences to "pad" the ramps some, but I suspect the option would look really bad on LOR or hybrid LOR/D-Light networks.  I will look into this.


Edited by LightsOnLogan - 26 Nov 2008 at 1:29pm
Back to Top
Jonathan View Drop Down
Beta Testers
Beta Testers


Joined: 07 Sep 2008
Location: SoCal
Online Status: Offline
Posts: 1237
  Quote Jonathan Quote  Post ReplyReply Direct Link To This Post Posted: 26 Nov 2008 at 12:51pm
If you are using LED's, you'll see this.  That's because they only need a fraction of the power incandescents use.  So while an incandescent uses 0 - 100 in 240 steps, the LED's will do the same thing in far fewer steps. 
~Jonathan
Back to Top
Pony_God View Drop Down
Senior Member
Senior Member
Avatar

Joined: 01 Sep 2008
Location: Naples, FL
Online Status: Offline
Posts: 551
  Quote Pony_God Quote  Post ReplyReply Direct Link To This Post Posted: 26 Nov 2008 at 8:25am
How short/long are the fades?
Fine. You're so smart you rig up the lights.
D-Light users Unite!
Back to Top
beavis View Drop Down
Groupie
Groupie


Joined: 01 Sep 2008
Online Status: Offline
Posts: 15
  Quote beavis Quote  Post ReplyReply Direct Link To This Post Posted: 25 Nov 2008 at 11:40pm

My first controller from last year is running 1.13.  The new one I bought this year is 1.14, which I think only adds wireless support.  I haven't updated the 1.13 controller since I used it last year though, and it's driving the same fades it was last year.

Back to Top
LightsOnLogan View Drop Down
Admin Group
Admin Group


Joined: 11 Oct 2007
Online Status: Offline
Posts: 3187
  Quote LightsOnLogan Quote  Post ReplyReply Direct Link To This Post Posted: 25 Nov 2008 at 11:33pm
First question... what firmware is the controller running?  D-Light has been working on fixes for ramp timing so the ramps may vary depending on the firmware version .
Back to Top
beavis View Drop Down
Groupie
Groupie


Joined: 01 Sep 2008
Online Status: Offline
Posts: 15
  Quote beavis Quote  Post ReplyReply Direct Link To This Post Posted: 25 Nov 2008 at 11:27pm
Just fired our show up for the first dry run.  I was on spectrum last year, and it seems like the fading is much less subtle than it was with Spectrum.
 
Like where there's a long fade out from 100 to 0, the channel seems to turn completely off well before the end of the interval.
 
Anyone else seen this?  Also it seems like short quick fades that worked ok in spectrum now act erratically in Aurora.  More of a quick flash than a quick fade.
 
Any suggestions on how to handle this better?
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down

Bulletin Board Software by Web Wiz Forums® version 9.06
Copyright ©2001-2007 Web Wiz

This page was generated in 0.766 seconds.