lights to controller

i want to thank all that helped ( or tried ) but still have same problem cannot get lights to play   thanks again john

ok. lets make sure you have everything set right.

1.  Under setting---serial network configuration---you clicked  ADD Network.  In that window you chose network 1 and the correct Com port and then clicked add.  You should see the network listed.....Network 1, comport #, Data Rate 56000?

2.  All your channels are configured to the SAME device number as your controller?

3.  You have lights commands on your sequence?

4.   You pressed the light bulb?

5.   You hit play and the light on the controller went solid right before the music started?

6.    Music played?

who makes the board?  d-light or LOR?

d light

auto