Aurora Homepage
Forum Home Forum Home > Aurora Sequencer Software > Aurora 1.0 > Bug Reports
  Active Topics Active Topics
  FAQ FAQ  Forum Search   Calendar   Register Register  Login Login

changing ramp style

 Post Reply Post Reply Page  <12
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Jonathan View Drop Down
Beta Testers
Beta Testers


Joined: 07 Sep 2008
Location: SoCal
Online Status: Offline
Posts: 1237
  Quote Jonathan Quote  Post ReplyReply Direct Link To This Post Posted: 15 Oct 2009 at 4:15pm
Ok, so the firmware on the controller is 1.14, which does support ramping shimmers.  Now, what controller firmware is selected for your channels in Aurora?  Right click in the channel area and choose open the BCE.  The device type you selected when you first set up the controller will be displayed.  Make sure it is set to D-Light ACx16 1.13+, not pre 1.13.  It is set to 1.13+, yes?
~Jonathan
Back to Top
onewish1 View Drop Down
Newbie
Newbie


Joined: 09 Sep 2009
Online Status: Offline
Posts: 34
  Quote onewish1 Quote  Post ReplyReply Direct Link To This Post Posted: 15 Oct 2009 at 5:22pm
yes that is correct... it's very strange.. I did a sequence today and had no problem with it

wonder why it only freaked out that one day
Back to Top
onewish1 View Drop Down
Newbie
Newbie


Joined: 09 Sep 2009
Online Status: Offline
Posts: 34
  Quote onewish1 Quote  Post ReplyReply Direct Link To This Post Posted: 20 Oct 2009 at 9:54pm
bad news it was not a one time event.. it happened again today..

it was in a sequence with regular ramps and shimmer ramps.. all in the same column .. saved my work..  closed the program.. opened it back up and some of the regular ramps changed to shimmer and the shimmer changed to regular ones.. not on all of them.. but quite a few
Back to Top
 Post Reply Post Reply Page  <12

Forum Jump Forum Permissions View Drop Down

Bulletin Board Software by Web Wiz Forums® version 9.06
Copyright ©2001-2007 Web Wiz

This page was generated in 0.750 seconds.