Aurora Homepage
Forum Home Forum Home > Aurora Sequencer Software > Aurora 1.0 > Installation Issues
  Active Topics Active Topics
  FAQ FAQ  Forum Search   Calendar   Register Register  Login Login

Sequence not playing

 Post Reply Post Reply Page  <12
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
teknode1 View Drop Down
Newbie
Newbie


Joined: 02 Dec 2008
Online Status: Offline
Posts: 7
  Quote teknode1 Quote  Post ReplyReply Direct Link To This Post Posted: 16 Dec 2009 at 9:53pm
_popupControl(); FYI,  to all concerned I was able to finally get the Sequencer to work.  I went to Fry's and bought a pci card with two USB connections, and of course while I just happened to be there bought a card to run two monitors.  I installed both and now not only will the USB on the card work but the USB connections on the motherboard works just fine.  I did not load any drivers for the USB card and just let XP do whatever it does.  This is confusing considering I had completely removed the com and USB section in Device Manager and rebooted numerous times trying many different combinations of slots, comms and boards installed.  After the holidays I will look to see what the USB card installed or changed and pass along anything of importance.
 
Regards,
Rick  
Back to Top
 Post Reply Post Reply Page  <12

Forum Jump Forum Permissions View Drop Down

Bulletin Board Software by Web Wiz Forums® version 9.06
Copyright ©2001-2007 Web Wiz

This page was generated in 0.531 seconds.