Aurora Homepage
Forum Home Forum Home > Aurora Sequencer Software > Aurora 1.0 > Bug Reports
  Active Topics Active Topics
  FAQ FAQ  Forum Search   Calendar   Register Register  Login Login

Crash when opting not to proceed with "new" Seq.

 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
frankr View Drop Down
Newbie
Newbie


Joined: 25 Jul 2009
Online Status: Offline
Posts: 19
  Quote frankr Quote  Post ReplyReply Direct Link To This Post Topic: Crash when opting not to proceed with "new" Seq.
    Posted: 05 Dec 2009 at 3:50am
Steps to reproduce.

File->New

When the media author dialog box is up on the screen if you choose cancel rather then adding a media file and choosing ok Aurora will crash.

Back to Top
Jonathan View Drop Down
Beta Testers
Beta Testers


Joined: 07 Sep 2008
Location: SoCal
Online Status: Offline
Posts: 1237
  Quote Jonathan Quote  Post ReplyReply Direct Link To This Post Posted: 05 Dec 2009 at 10:48am
That's a known issue, however, it's not a show stopper, so the recommended advice is to either go ahead and setup a new file (you can then open the file you wanted, no need to save the new file) or you can let the program close out, open it again, and choose to open the file you were intending to open.   

There are also instances where File, Exit can cause the program to crash.  For that one, since the intent was to close the program, you can use the red "X" or simply let it error out.  That issue falls in the same boat as the above--  noted, and will be fixed at some point in the future.
~Jonathan
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down

Bulletin Board Software by Web Wiz Forums® version 9.06
Copyright ©2001-2007 Web Wiz

This page was generated in 0.280 seconds.