D-light controller template
Printed From: Aurora
Category: The Vault
Forum Name: I'm New From Spectrum And I Need Help!
Forum Discription: General usage questions from former Spectrum users
URL: http://www.aurorashow.com/forum/forum_posts.asp?TID=304
Printed Date: 09 May 2024 at 5:06pm
Software Version: Web Wiz Forums 9.06 - http://www.webwizforums.com
Topic: D-light controller template
Posted By: mramsey
Subject: D-light controller template
Date Posted: 09 Sep 2008 at 6:36pm
|
I would like to set up a d-light controller template (3 ACX16"s) I can't seem to do this without adding a song in spectrum to bring over to Aurora (is this the way then change to the song you wish to use). Also, Aurora is only showing 16 channels in the sequence out of 48. How have others done it??? ------------- http://www.d-light.us"> 
|
Replies:
Posted By: LightChristmas
Date Posted: 09 Sep 2008 at 7:02pm
|
Things to check
Serial Network Config: Is Aurora configured for Network 1 and the proper COM port for your RS485/WiLink
Aurora Channel Properties: Make certain each channel is set for the Network Segment you assigned in the Serial Network Config; and that the proper controller number is assigned.
You an change the song in Aurora at any time.
Aurora will kill duplicate channel name tags (you can't have two channel named GARAGE, for instance or two controllers with the same Device ID) ------------- http://www.aurorashow.com/"> 
|
Posted By: ChrisL1976
Date Posted: 09 Sep 2008 at 8:11pm
|
I've also found that when I used Virtual Controllers in spectrum, for some reason it created duplicate channels on the same controller.....Among others, I had a Left Window and a Right Window channel in spectrum, when I brought the sequence into Aurora, the Right Window did not get brought in. I had to go back in spectrum and Sort the controller by channel. (right click feature on the controller), then go channel by channel to make sure they are 1-16 for each controller.
------------- Chris www.lightsonsixth.com |
Posted By: mramsey
Date Posted: 09 Sep 2008 at 8:17pm
|
Thanks for the help. I did stumble across Serial Network Config. and I can output to one controller. I will also try the other suggestions ------------- http://www.d-light.us">
|
Posted By: mramsey
Date Posted: 10 Sep 2008 at 4:02pm
I see by naming the channels in one controller 1 - 16 the next controller 1b - 16b, 1c - 16c they all imported fine thanks Next I ' ll have to try outputting to all 3 controllers ------------- http://www.d-light.us">
|