D-light DC-16 controller
Printed From: Aurora
Category: The Vault
Forum Name: I'm New From Spectrum And I Need Help!
Forum Discription: General usage questions from former Spectrum users
URL: http://www.aurorashow.com/forum/forum_posts.asp?TID=389
Printed Date: 23 May 2024 at 4:51am
Software Version: Web Wiz Forums 9.06 - http://www.webwizforums.com
Topic: D-light DC-16 controller
Posted By: pwalstead
Subject: D-light DC-16 controller
Date Posted: 15 Oct 2008 at 11:47pm
| Sequencer won't operate any of the channels on my controller. The D-Light hardware utility works fine. But when Aurora is playing back the sequence the LED stops blinking to indicate communications but no voltage(tested with lights and a DVM). |
Replies:
Posted By: ChrisL1976
Date Posted: 16 Oct 2008 at 7:37am
|
Have you made sure that you have the D-light DCx16 firmware 1.13 picked as the controller for each channel? I know there is one that says D-light DCx16 (lor) ------------- Chris www.lightsonsixth.com |
Posted By: JonB256
Date Posted: 16 Oct 2008 at 7:50am
|
Double checking. Be sure Device type is correct. If you have made changes to the DCx16's ID number, it never hurts to restart the device by turn off the power. Be sure to click on the "Light Bulb" right under the word Playback at the top of the screen. It should be RED to get active output. And I'll assume you have the Serial Network set to the same COM port that your HW Util is using?
------------- JonB - D-Light user |
Posted By: pwalstead
Date Posted: 16 Oct 2008 at 10:46am
| Yep everything was as you outlined. Like I said if I used the hardware utility by itself it controlled the outputs fine. I was able to resolve the problem by running the hardware utility from the add-ins portion of the toolbar from within Aurora. Once I set the address from there everything worked fine. |