need some help!!!!
Printed From: Aurora
Category: Aurora Sequencer Software
Forum Name: Questions About Aurora
Forum Discription: Considering ordering but want more info from other Aurora users?
URL: http://www.aurorashow.com/forum/forum_posts.asp?TID=538
Printed Date: 09 May 2024 at 8:45am
Software Version: Web Wiz Forums 9.06 - http://www.webwizforums.com
Topic: need some help!!!!
Posted By: breakbenj
Subject: need some help!!!!
Date Posted: 26 Nov 2008 at 9:02pm
|
I have put up all the lights and hooked them to the right channels but it seems that controller 1 is the only one receiving commands and controller 2 just provides power but does not make the lights do anything, I tested this by creating a sequence that turned each channel on for 15 seconds and the channels on the first conroller turned the lights on when they were supposed to but they also turned on random channels on the second controller and when the sequence got to the point where the second controller's channels are nothing turned on. All I can think of is a data cable problem in which the second contoller does not get commands from the first. ------------- Jeff  
|
Replies:
Posted By: LightChristmas
Date Posted: 26 Nov 2008 at 9:36pm
|
Yup. Cable is a good first place to look. Second is make sure your channel addressing is kosher and not set for NETWORK 2 or something.
------------- http://www.aurorashow.com/"> 
|
Posted By: bdkeen
Date Posted: 26 Nov 2008 at 10:56pm
|
Might also insure that the device ID is set unique for both controllers and for some reason you don't have 2 controllers on the same id. ------------- 
|
Posted By: breakbenj
Date Posted: 27 Nov 2008 at 9:32am
|
Thanks I will check both of those issues after thanksgiving dinner and if the channel adresses and device id are correct it has to be the data cable right? ------------- Jeff
|
Posted By: LightChristmas
Date Posted: 27 Nov 2008 at 10:07am
One would think so.There are more things in heaven and earth, Horatio, than are dreamt of in your (our) philosophy. |
