Aurora 1.0: how to setup lights opposite of show

Print Page | Close Window

how to setup lights opposite of show

Printed From: Aurora
Category: Aurora Sequencer Software
Forum Name: Aurora 1.0
Forum Discription: This is the place to discuss (and report bugs) the 1.0 version of Aurora
URL: http://www.aurorashow.com/forum/forum_posts.asp?TID=543
Printed Date: 04 Nov 2025 at 1:47am
Software Version: Web Wiz Forums 9.06 - http://www.webwizforums.com

Topic: how to setup lights opposite of show

Posted By: lowinhz
Subject: how to setup lights opposite of show
Date Posted: 27 Nov 2008 at 9:38pm

i would like to turn on lights when a show is not running and off when a show is 13 amps no more channels to spare and cant get a new controller this year any ideas i want it to be auto if possible

Replies:

Posted By: Jonathan
Date Posted: 27 Nov 2008 at 11:26pm

If power requirements are too much for your controllers to handle, that's not something the scheduler can address. It's up to you to make sure you don't go over your power limits.

If you want lights to remain on after the show has ended, you have to do that trick where you go to the end of your last sequence, zoom out so you can see past it, and then using the y tool change the 0% to 100% for each channel. When the scheduler ends for the night, the lights will remain on until either the next song or the next show. A much easier way is to just create a blank audio file for whatever time you need in Audacity, then just have the lights on in the sequence.

-------------
~Jonathan