Print Page | Close Window

Aurora will not send to lights

Printed From: Aurora
Category: Aurora Sequencer Software
Forum Name: Installation Issues
Forum Discription: This is the place to discuss issues with installing Aurora
URL: http://www.aurorashow.com/forum/forum_posts.asp?TID=906
Printed Date: 29 Mar 2024 at 5:06am
Software Version: Web Wiz Forums 9.06 - http://www.webwizforums.com


Topic: Aurora will not send to lights
Posted By: James
Subject: Aurora will not send to lights
Date Posted: 27 Nov 2009 at 8:24pm

 When I go to send  to run the lights all it does is plays it back on the screen. The lights do not do anything. I have tryed to fire one board at a time. Still no lights. Aurora seems to have done all that it should, but is not linking with my lights.  Anyone have any recommendations?   Thanks for any help you can offer!

James



Replies:
Posted By: Jonathan
Date Posted: 27 Nov 2009 at 9:12pm
Things to try:

1)  Click the light bulb.  If it is red, it will output to the lights.

2)  Ensure network 1 is set to the proper COM port.  You can do this in either Aurora Sequencer, or Borealis Scheduler.  The settings from one will carry over to the other.

3)  Exit or disconnect from the HW Utility.  The port must be open for the commands to be sent.


-------------
~Jonathan


Posted By: James
Date Posted: 27 Nov 2009 at 10:03pm
Jonathan,
Thank you very much. It seems that the problem was with the utility running.
I thought that this was to be running at the same time. I wish that I knew this
last night when I had the family all here for dinner & the starting of the lights.
 
Thanks again you saved me and my hair


Posted By: Jonathan
Date Posted: 27 Nov 2009 at 10:59pm
You are welcome.  I'm glad it's working ok for you.  

-------------
~Jonathan



Print Page | Close Window

Bulletin Board Software by Web Wiz Forums® version 9.06 - http://www.webwizforums.com
Copyright ©2001-2007 Web Wiz - http://www.webwizguide.com