problems with channels

well not sure how or why but deleted the old lights and drew the same thing back in and vi'ola.  CPU fart i guess?
 

Thanks, Les

Yes the channel properties only goes up to 16.  But what i mean is the four channels that i added would be in running order 17-20 (counting from the top down).
1st. Controller Id = 3  channels 1-16
2nd. Controller Id = 5  Channels 17-32

Id's are set correctly because they output like i sequenced them.

 However when im using the visualizer they dont operate like i sequenced them.
In the visualizer channel 1-4 are skulls.  And channel 17-20 (if you will) are pumpkins. When i watch the visualizer the pumpkins are doing the same thing the skulls are doing. 

Do you think this has something to do with having the same number in the " Channel properties"?

       Thanks for the help, Les


Edited by polarass07 - 10 Oct 2008 at 9:27pm

Originally posted by polarass07 Visualizer prob. kind of fixed but, i added 4 more channels on my aurora sequence and drew the lights. When i play it back in the visualizer the new channels ( which should be 17,18,19,20 but are listed in the channels properties as 1,2,3,4) blink like channels 1-4 on my first controller. How do i get away from this? Les

How exactly did you number any channels 17,18,19,20???  From what I've seem, the Channel list only goes up to 16.   Do you mean Device number?

I went through and deleted  the extra 16 channels that i added in the spectrum but it didnt help with the visualizer. I might end up programming the rest of that song without a visualizer.

I started a new song  (16 channels) on aurora and just about completed it. I tried to add my second controller (another 16 channels) and couldnt figure it out.  Back to spectrum got both controllers loaded,  Now i reimported the sequence and my visualizer wont show any light effects.   The error it said was virtual memory was low... So i added another 512mb so now im at one gig. But still nothing.  im at a loss and looking for suggestions.