Aurora Homepage
Main Hardware Software Cables/Adapters Forum Contact
Forum Home Forum Home > Aurora Sequencer Software > Aurora 1.0 > Installation Issues
  Active Topics Active Topics
  FAQ FAQ  Forum Search   Calendar   Register Register  Login Login

Aurora will not send to lights
 Post Reply Post Reply
Author
Message Reverse Sort Order
  Topic Search Topic Search  Topic Options Topic Options
Jonathan View Drop Down
Beta Testers
Beta Testers


Joined: 07 Sep 2008
Location: SoCal
Online Status: Offline
Posts: 1237 		  Quote Jonathan Quote  Post ReplyReply Direct Link To This Post Topic: Aurora will not send to lights
    Posted: 27 Nov 2009 at 10:59pm
You are welcome.  I'm glad it's working ok for you.  
~Jonathan
Back to Top
James View Drop Down
Newbie
Newbie
Avatar

Joined: 17 Nov 2008
Location: Meridian, Id.
Online Status: Offline
Posts: 2 		  Quote James Quote  Post ReplyReply Direct Link To This Post Posted: 27 Nov 2009 at 10:03pm
Jonathan,
Thank you very much. It seems that the problem was with the utility running.
I thought that this was to be running at the same time. I wish that I knew this
last night when I had the family all here for dinner & the starting of the lights.
 
Thanks again you saved me and my hair
Back to Top
Jonathan View Drop Down
Beta Testers
Beta Testers


Joined: 07 Sep 2008
Location: SoCal
Online Status: Offline
Posts: 1237 		  Quote Jonathan Quote  Post ReplyReply Direct Link To This Post Posted: 27 Nov 2009 at 9:12pm
Things to try:

1)  Click the light bulb.  If it is red, it will output to the lights.

2)  Ensure network 1 is set to the proper COM port.  You can do this in either Aurora Sequencer, or Borealis Scheduler.  The settings from one will carry over to the other.

3)  Exit or disconnect from the HW Utility.  The port must be open for the commands to be sent.
~Jonathan
Back to Top
James View Drop Down
Newbie
Newbie
Avatar

Joined: 17 Nov 2008
Location: Meridian, Id.
Online Status: Offline
Posts: 2 		  Quote James Quote  Post ReplyReply Direct Link To This Post Posted: 27 Nov 2009 at 8:24pm

 When I go to send  to run the lights all it does is plays it back on the screen. The lights do not do anything. I have tryed to fire one board at a time. Still no lights. Aurora seems to have done all that it should, but is not linking with my lights.  Anyone have any recommendations?   Thanks for any help you can offer!

James
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down

Bulletin Board Software by Web Wiz Forums® version 9.06
Copyright ©2001-2007 Web Wiz

This page was generated in 0.188 seconds.