![]()
|
Lights firing at the wrong time. |
Post Reply ![]() |
Author | |
HarleyHaynes ![]() Newbie ![]() ![]() Joined: 21 Dec 2008 Location: Kingwood, Texas Online Status: Offline Posts: 10 |
![]() ![]() ![]() Posted: 30 Dec 2008 at 10:31pm |
I got the issue worked out. Newbie I D 10 t error
![]() |
|
![]() |
|
Jonathan ![]() Beta Testers ![]() Joined: 07 Sep 2008 Location: SoCal Online Status: Offline Posts: 1237 |
![]() ![]() ![]() |
What kind of strands are misfiring? Are they LED's?
What version of Aurora are you using? (1.0.41?) Does this also occur in Borealis Scheduler, or just the sequencer? |
|
~Jonathan
|
|
![]() |
|
HarleyHaynes ![]() Newbie ![]() ![]() Joined: 21 Dec 2008 Location: Kingwood, Texas Online Status: Offline Posts: 10 |
![]() ![]() ![]() |
I have an almost complete sequence but when I test it through Aurora it has 2 channels firing at the same time when I have clearly made sure they should not be firing at the same time. I first thought this was an issue with ramps so I turned all the ramps to on an still getting the same problem. It only happens during one small part of the sequence. When viewing in visualizer it seems fine but when I send to lights is when the issue begins. It only seems to be 2 channels doing this as well. Rest of the sequence seems to run fine. At first I thought I had a couple of channels plugged in to the wrong output cords but when I check in hardware utility everything seems fine.
Edited by HarleyHaynes - 21 Dec 2008 at 9:42pm |
|
![]() |
Post Reply ![]() |
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |