Aurora 1.0.90 In DMX Mode: D-light USB Adapter to Lynx Express cable

Print Page | Close Window

D-light USB Adapter to Lynx Express cable

Printed From: Aurora
Category: Aurora Sequencer Software
Forum Name: Aurora 1.0.90 In DMX Mode
Forum Discription: Using the unofficial DMX patch
URL: http://www.aurorashow.com/forum/forum_posts.asp?TID=1106
Printed Date: 28 Apr 2025 at 2:18pm
Software Version: Web Wiz Forums 9.06 - http://www.webwizforums.com

Topic: D-light USB Adapter to Lynx Express cable

Posted By: crichter
Subject: D-light USB Adapter to Lynx Express cable
Date Posted: 14 Jan 2011 at 2:14pm

I have created the following cable to test DMX output from Aurora using the D-light USB adapter to a Lynx Express controller with success.

Basically it is a standard TIA/EIA-568B crimp on one end and then swapping pins 1 to 4 and 2 to 5 on the other.

Here is a link to a drawing of the cable: http://www.lightsoncallaway.com/images/DMX_cable.gif - http://www.lightsoncallaway.com/images/DMX_cable.gif

Note: This may or not be the correct way to adapt the dongle to DMX and I am simply sharing this as my personal experience of success. Use at your own risk.

-------------
Curt

Replies:

Posted By: JonB256
Date Posted: 19 Jan 2011 at 5:20pm

I made a similar adapter cable but found that I needed to connect Pin 1 to Pin 5 and Pin 2 to Pin 4. I just used a short cable with an RJ-45 on one end and the other end's wires inserted into a Keystone Jack (made it easy to swap the wires when it didn't inially work)

Only then did it control.

-------------
JonB - D-Light user

Posted By: JonB256
Date Posted: 24 Jan 2011 at 6:13am

Originally posted by crichter

I have created the following cable to test DMX output from Aurora using the D-light USB adapter to a Lynx Express controller with success.

crichter, in your testing, did you possibly have the Lynx controller respond as "One channel" off? That has been my experience with an unmodified D-Light USB adapter used as an Open DMX dongle. On one type of controller I own, the channel response was as 51 when it was set to be 50.

This was a 3-channel 12vdc controller. Reliably off by one.

If I used the Lynx DMX Dongle, it was correct.

-------------
JonB - D-Light user

Posted By: crichter
Date Posted: 27 Jan 2011 at 8:46pm

Hi Jon,

Sorry for the delayed response, been kinda busy here. I just tested output again and confirmed the channels were correct for me. I had the following setup: PC--D-light USB--Lynx Express channels 1-16. I also tested with the controller's start channel being 33.

-Curt

-------------
Curt